Loading...

Bob Smith Industries Insta-Cure, Insta-Cure+ and Maxi-Cure CA Comparison by ModelMerchants.com

3,975 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Aug 15, 2015

We compare Bob Smith Industries' three main types of Cyanoacrylate glues (Insta-Cure, Insta-Cure+ and Maxi-Cure) and explain the differences between them, along with a few demonstrations of the types of applications you can use each one for. For a special discount, click the link below.

Visit us online at http://www.modelmerchants.com

Bob Smith Insta-Cure: https://modelmerchants.com/shop/insta...
Bob Smith Insta-Cure+: https://modelmerchants.com/shop/bob-s...
Bob Smith Maxi-Cure: https://modelmerchants.com/shop/bob-s...

Bob Smith Industries Cyanoacrylate Glue Descriptions:

Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface bond.

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.

Maxi-Cure™ extra thick CA is the best CA for most plastics, including GE’s Lexan MAXI-CURE™ is the best choice for plastic model assembly. When used with INSTA-SET™, it works better than any putty for modifying or filling voids. It can be carved with a knife or razor blade and sanded and feathered to form a finish indistinguishable from plastic. MAXI-CURE™ bonds fiberglass, hardwood, metal and rubber better than any other hobby adhesive. For gluing to the inside, clothtextured surface of fiberglass, scrape the area to be bonded with a razor blade or coarse sandpaper before using MAXI-CURE™ or any other adhesive. It also is best for bonding the tires for R/C cars.

Please leave any comments/suggestions in the comment box below.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...