Rick's Hobbies
Loading...
512
subscribers
1,695,556
video views
Uploaded videos
1-10 of 34-
Miniature "222" hit-n-miss Engines All Running
popnstart
170 views
The "222"(2.22 cu.in.) miniature hit-n-miss engines each seem to have their own unique personality. Some run faster than others. Some "hit" harder than others. Some start o...
-
Miniature "222" Hit-n-Miss Assembly
popnstart
116 views
The boss wanted chrome plated flywheels so this was an opportunity to show how some of the ways to assemble the "222".
-
True Involute Planetary Gear Component Procedure(720pHD)
popnstart
169 views
This video shows an easier method of sketching True Involute Internal and External gear tooth profiles with backlash. These gear teeth incorporate a 25-degree pressure angl...
-
Build Procedures of the "222" Mini Hit-N-Miss (Episode 1)
popnstart
610 views
Build Procedures of the "222" (Part 1)
-
Mini "222" rev-up!
popnstart
358 views
I like to heat-up the "222" 's by applying a load, and then tuning them to run as slow as possible. Jay likes to run his just short of destruction. "Hey, I'll just rebuild ...
-
Jay's miniature bar-stock Hit-n-Miss engine warm-up!!
popnstart
1,425 views
The engine I have tagged as the "222"(2.22 cubic in., 36cc) has a 1.25 in.bore and 1.8125 stroke. Burns Coleman lantern fuel with a dab of 2-cycle oil for cylinder lubricat...
-
Brandon's miniature Hit-n-Miss Engine warm-up
popnstart
609 views
This is a procedure we use to warm-up Brandon's "222" mini hit-n-miss engine. A hit-n-miss engine runs much slower and better when the engine heat migrates to the "mixer" a...
-
MINIATURE HIT-N-MISS powered CAN CRUSHER
popnstart
2,717 views
Rose demonstrates to the world the proper operation of an aluminum can crusher. Powered by a miniature homemade hit-n-miss engine through a planetary gear clutch system ren...
-
Model Hit n Miss engine (1st Model & 1st Run)
popnstart
2,657 views
Shot glass gas tank, home-made model hit-n-miss engine uses Coleman fuel(with 40:1 tcw3 2 cycle oil), 1-1/4 bore x 1-9/16 stroke 12V coil timed thru GM points, H-D crankpin...
-
Autocad Internal Gear Demo(TRUE INVOLUTE)
popnstart
3,429 views
Save your hard earned bucks and learn the method I use to draw TRUE INVOLUTE INTERNAL gears with Autocad. The formulas and sketch descriptions are used in the "AutoCad Gear...
Advertisement
Play all(34)