Why?
Loading...
35
subscribers
194,704
video views
Uploaded videos
1-10 of 43-
18102010030.mp4
MrEngineer
70 views
This is a LED sequence I am doing for a Helmet. Because of the memory limitations, I used interrupts to detect switch presses. There are 13 patterns and due to the interrup...
-
03102010017.mp4
MrEngineer
167 views
This is a Playmates Phaser which I finished modifying about two hours before his deadline. A lot of features were taken out but he is still pleased with it.
-
10082010010.mp4
MrEngineer
61 views
My first every attempt on using a PIC on a toy. I gutted it, save for the battery terminals, put in the electronics without using any PCB and just used wire-wrapping wires ...
-
02072010067.mp4
MrEngineer
75 views
This is the modified version of the off-the-shelf down counter i did earlier. After more explanations from nexus, what is needed is another button to act as a "trigger" whi...
-
27062010065.mp4
MrEngineer
72 views
Off the shelf 3-digit Countdown circuit and LED badge for nexus. This is using ready-made electronics kits from Nixie Electronics; down counter module, 3-digit display and...
-
23042010051.mp4
MrEngineer
13,000 views
This is a video showing different stages of modifications done to the Iron Man II Arc Reactor toy.
-
05042010050.mp4
MrEngineer
334 views
I got my eFX Mark IX Tricorder on Friday, 02042010!
-
28022010053
MrEngineer
73 views
This is a remote controlled RGB Module which runs on 12 volts.
-
28022010051
MrEngineer
146 views
This is an experiment for Kal on the Boba Fett Chest armour display. There are two alternatives.....
-
27012010038.mp4
MrEngineer
57 views
I used a PIC to drive a LED strip. Because I was a bit busy, I just used two switches to control the dimming speed instead of getting the correct PIC to read data from a va...
Play all(43)