LED Lighting Page

LEDDistributors commented 6 months ago

2:31 Add to

Flexible LED Light Strip - Cut and Connect DIY

This is a short DIY video on how to cut and connect Flexible LED Strip. It is intended as an instructional video from the www.leddistributors.net D...

87,078 views

LEDDistributors said:

@ikelleners - I would do a touch test. Once you turn the panel on, touch the LEDs. They should be warm to the touch. Recheck periodically. If you feel that they are getting hot then you might think about cooling them. There are a few ways of cooling LEDs. You can use fans or heat sinking. It's id...

• 2:31 Add to

  Flexible LED Light Strip - Cut and Connect DIY

  This is a short DIY video on how to cut and connect Flexible LED Strip. It is intended as an instructional video from the www.leddistributors.net D...

  87,078 views

  LEDDistributors said:

  @SteveSabbai - Yes, it is possible. you would connect an on/off switch in line. You can connect it on the negative wire. The switch can be a slide switch, push-button or toggle.

• 2:31 Add to

  Flexible LED Light Strip - Cut and Connect DIY

  This is a short DIY video on how to cut and connect Flexible LED Strip. It is intended as an instructional video from the www.leddistributors.net D...

  87,078 views

  LEDDistributors said:

  @Gtbomb1 - Yes, I am not sure of the exact connection but I believe if you connect to the speakers input, the lights will flash to the beat. I would test first.

• 2:31 Add to

  Flexible LED Light Strip - Cut and Connect DIY

  This is a short DIY video on how to cut and connect Flexible LED Strip. It is intended as an instructional video from the www.leddistributors.net D...

  87,078 views

  LEDDistributors said:

  @DarkSpawnProductions A 12V power adapter will work fine for your project. Let us know how it goes.

• 2:31 Add to

  Flexible LED Light Strip - Cut and Connect DIY

  This is a short DIY video on how to cut and connect Flexible LED Strip. It is intended as an instructional video from the www.leddistributors.net D...

  87,078 views

  LEDDistributors said:

  @alanr1995

  We used 24 gauge stranded wire on this video. I believe that speaker wire is 24 gauge. You can use 22 or 20 gauge as well. It can get difficult to solder, if the wire is too thick.

• 2:33 Add to

  Flexible LED Light Strip - Cut and Connect DIY

  A short DIY video on how to cut and connect Flexible LED Strip. It is intended as an instructional video from the www.leddistributors.net DIY team.

  6,751 views

  LEDDistributors said:

  4. Once the iron is completely hot, hold the hot tip on the copper pads for a few seconds to preheat the surface of the pads.

  5. Introduce the solder to the tip of the iron (in the V, where the iron tip touches the copper pad. You will have to hold it there for a few seconds until the solder melt...

+ One more videoshow less