Successfully removed.
Sorry, an error occurred.
|
BadShoeProductions uploaded a new video
(2 months ago)
This short compressed video clip shows how to test the throttle position sensor on a 5.0L Ford engine with EEC 4 electronics. Test include the TPS ...
more
This short compressed video clip shows how to test the throttle position sensor on a 5.0L Ford engine with EEC 4 electronics. Test include the TPS signal, reference voltage, signal return and explains how the sensor operates. This is just a scene from a much longer chapter on EEC 4troubleshooting which is one part of my copyrighted 5.0L Engine Swap into a Fox Platform volume 2. This four hour volume is the second in a two volume series on installing a 5.0L EFI engine and wiring change over. I use an 88 Turbo Coupe but the info applies to any Fox bodied car and the electrical information could be for a street rod project. If you want to find out more about this video or other "How To" DVD's, please check my web site, www.badshoeproductions.com
less
|
|
| |
|
|
BadShoeProductions uploaded a new video
(1 year ago)
I have now finished two volumes on "Swapping a 5.0L engine into a Fox body Ford". This is a short clip from the valve lash adjustment cha...
more
I have now finished two volumes on "Swapping a 5.0L engine into a Fox body Ford". This is a short clip from the valve lash adjustment chapter in volume one. Understand, this video clip is for setting non-adjustable pedestal rocker arm. When I torque the rocker bolts down, they are fully tightened to the head. All checks for pushrod length and rocker tip contact were checked earlier in the DVD. The finished video series shows what is needed when installing a V8 into a Fox platform that may have had a 4 or 6 cylinder engine originally. The Fox that I'm using in this production is an 88 Turbo Coupe TBird and the engine is from a 99 Explorer. This video can be used when swapping a 5.0L into any Fox platform. In the first volume, I pull the 4 cyl. and A4LD trans. from car, make changes to the engine so it can fit in a Fox frame as well as do a partial tear down of the engine. The AOD tranny is installed in volume 2 which is the same one that I overhauled in my "How To Overhaul the Ford AOD" repair video. The engine is pretty much stock in vol. 1, however I show how to install a high lift cam, degree it in, check piston to valve clearance, talk about valve train geometry and how to set valve lash. I also do simple bearing and cylinder wall wear measurements. Volume 2 has chapters on putting the drivetrain together, wiring/plumbing engine for EEC IV EFI, and how to troubleshoot electronic fuel injection. I may add future updates on building and tuning an aftermarket "stand-alone" controller, maybe even a turbo or supercharger installation. I'm asking you, the car guy enthusiast and former customers to suggest to me what I should add to this video project. Drop me an email with your thoughts. Volume one and two is finished and ready for sale now. Please go to my web site for project updates and info on all of the BadShoe series "How To" copyrighted DVD's. Thanks...Ken "BadShoe" Collins.
www.BadShoeProductions.com Instructional videos specializing in Ford drivetrains
less
|
|
Thanks Ricky Snow