Loading...

Briggs and Stratton Intek OHV 18HP rebuild (part 2)

69,902 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Aug 31, 2012

For this part you need, a hammer, 9/16 socket, needle nose pliers, oil, ring compressor(15$), Torque 40 bit, torque wrench(30-40$), and a bunch of patience.
Good luck! Thanks for watching.

Disclaimer

Due to factors beyond the control of Alex S "Multikhaz", it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Alex S "Multikhaz" assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Alex S "Multikhaz" recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Alex S "Multikhaz" no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Alex S "Multikhaz".

Loading...

Advertisement
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...