Loading...

Moving the solder jumpers on NIStune boards

12,519 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Apr 18, 2014

A quick tutorial on how to add/remove the SMD solder jumpers used on all NIStune boards.

These jumpers are used to switch between program mode (flash a base image to allow the board to be used for a different ECU) and "run" mode (when ECU is fitted to an ECU and run in a vehicle).

*** Moving these jumpers is only required if you're re-flashing the base image. Most end users should never have to touch them. ***

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...