FPV Head Tracking Gyro X-1000 Setup with Fly Sky Th9x Turnigy 9x with Pan/Tilt - Mod - It's ALIVE!





The interactive transcript could not be loaded.



Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Feb 20, 2012

I was able to setup my Flysky TH9x (turnigy 9x) transmitter to accept the Gyro X-1000 from Hobbyking. Three quick solder points and a few settings later, I was in business. I had to solder it to the back pcb board of the transmitter to force it to work. Whe you do things on a budget youre force to hack things; less money means more work. On the vertical set of solder points the second from the bottom is ground and the third fom the bottom is positive (power). On the bottom row of solder points the second from the left is the signal point, and this is where the green wire in my case went. (You may have to pause the video to see all of this). To "awaken" your Camera, use the settings below.

If you like my vidos - in all of their low-budget glory - SUBSCRIBE. Good things happen to those who subscribe!

Transmitter Settings:

In the trainer menu you just change STATE TO OFF

All the channels to OFF and the GYR and FLP to NORM

In aux-CH ch the CH 5 to HOV PIT and CH 6 to HOV THRO

Gyro Settings:

Set the pan channel to 5
Set the tilt channel to 6
ch 5 angle to 90
ch 6 angle to 90
ch 5 reverse NO (one blink)
ch 6 reverse NO (one blink)

As always with all modifications its YOUR fault if you break YOUR stuff. Do these things at your own risk. I'm not responsible. But, you're smart and you already know that!


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...