Loading...

PCP Air Rifle Custom Gun Case Foam Evanix Blizzard S10

6,493 views

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Oct 5, 2011

The foam is upside-down for this video, normally the gun is carried right side up.

I googled rifle cases from my area and found that one from a local general/outdoors store, it's an unbranded one so it was cheap. Which was good since I ripped out the original foam leaving only the lid untouched.

The next step was to find a denser type of foam that would support the rifle cut outs, and the easiest and cheapest way for me was to buy camping mattresses made from EVA-foam from a local hypermarket.

I bought 3 mattresses (1 base & 2 for cut outs) measured and marked them with a pen. Then I cut everythind with normal household scissors, glued the layers together with again normal household glue.

Using scissors is much faster and easier than cutting the foam with a knife etc. But the scissors leave rough & serrated looking edges on the foam, so after the glue had dried I made all the edges smooth & cut outs true just by using normal sanding paper.

Comments are disabled for this video.
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...