 The collection event demonstrates how to repair a leak on a 200mm sewer pipe. Also in the event a ladle should be connected through a 110mm in-situ connector. During the three-minute event setup period, it's allowed to check and confirm that all equipment including bands to be used in the event are in satisfactory order. It's allowed to mark up the wet table where the leak is. Here we see gracing of the saw blade and the hole saw. The flexible couplings are to be adjusted so they fit on smoothly. The event starts by the team captain saying start and the operators go to each table. Here we see the operator cutting off a section at the wet table. When the section has been cut off it's important to clean off the ends of the pipe to make sure that the seal will be properly. Here we see the pre-mounting of the flexible couplings. At the dry table the operator drills a hole where the in-situ connector will be installed. Also here it's important to make sure that the edges have been cleaned before installing the rubber seal. After the rubber seal is installed it's allowed to grease up the connector and push it into place. After installing the in-situ connector the operator cuts off and removes a measured length of pipe in the dry table. Before installing the piece from the dry table it's important to clean off for grates. Here we see the team installing the couplings to finish off the installation. Before finishing the event it's important that all tools are back in the toolbox before ending the event.