 Welcome! The following video will demonstrate how to program a GoControl Smart Plugin Lamp Module into a GC2 panel. To program a GoControl Smart Plugin Lamp Module into a GC2 panel, ensure the panel and device are within 5 feet of each other. Next, navigate to the GC2 Z-Wave Toolbox. Press the Services button. Then press the Z-Wave button. Press the Wrench icon. Enter the installer code. The default installer code for the GC2 is 1, 5, 6, 1. You are now in the Z-Wave Toolbox. Z-Wave devices such as the Lamp Module may need to have past programming removed before they can be added to a panel, even if they are new. We do this by performing the removal process, which is also known as Exclusion. To begin the removal process, first connect the Lamp Module to the nearest AC outlet. Select the Remove Devices button. The Remove Z-Wave Devices screen will appear. Press and release the button on the front of the Lamp Module twice. You will see a notification on screen that the device was removed. Press OK. Press Back. Now you can add the Lamp Module. Press Add Devices. The Add Z-Wave Devices screen will appear. Press and release the button on the front of the module twice. You will see a notification on screen that the panel is querying device information. Do not exit the screen until you see the details for the Lamp Module controller display. Press Back to return to the Z-Wave Toolbox. If you have any additional Z-Wave devices, add them to the panel by repeating the steps discussed in this video. Then install the panel and all Z-Wave devices into their final locations. Lastly, complete a Network Rediscovery. During a Network Rediscovery, the panel will recreate its Z-Wave routing table and optimize the Mesh Z-Wave network. To initiate a Network Rediscovery, navigate to the Z-Wave Toolbox. Then press Advanced Toolbox. Press Rediscover Network. The panel will display a message that it is rediscovering the Z-Wave devices. Then the panel will automatically redirect you back to the Advanced Z-Wave Toolbox. Note, the panel will continue to run the Network Rediscovery process in the background. The Network Rediscovery will take around 1 to 2 minutes per Z-Wave device. Z-Wave services may be unavailable until Network Rediscovery is complete. Press the Home button on the panel. The Go Control Smart Plug-in Lamp Module has now been programmed into a GC2 panel. Make sure to subscribe to our YouTube page and click the Show More tab underneath the video so you can view valuable links pertaining to this product, similar how-to videos, and our low-cost, no-contract alarm monitoring services.