 Hey everyone, Drew with GeoArm and I am back to talk to you about enabling and disabling IntelliZone on the GeoAlarm control panel. Very very easy to do. First I'll go ahead and explain a little bit as to what IntelliZone is. IntelliZone is when you need two sensors to trigger in order for an alarm to occur. So what's going to happen is if you have a sensor, that sensor is opened once and then closed, it's not going to trigger the alarm. However, if that sensor, that very same sensor is open and closed again, it will trigger the alarm. What it's requiring is two triggers of alarms. The second one cannot be an interior follower, which is a motion detector or an interior device, motions. But it enables you to have an extra layer of security on the GeoAlarm control panel. So say you have your front door, you walk through your front door, it's not going to trigger it if IntelliZone is on because you don't want the front door to go off. Now if you walk into your living room and open that sliding glass door, at that point the alarm will trigger. What we're going to do is we're going to show you how to enable and disable it, hit the hamburger icon and then enter your code, then you're going to go under security. IntelliZone is over here to the left. All you're going to do is enable or disable it. I'm going to leave mine disabled, but that is how you enable and disable IntelliZone on the GeoAlarm control panel. If you guys have any questions or any comments, please leave them below. Other than that, take care and have a great day. or 877-443-6276 GeoAlarm, the worldwide leader in DIY security.