 Hey everyone, Drew with Geoalarm and I am back to talk to you about the Geoalarm system and how to get the GeoWFD water and freeze detecting sensor enrolled into the panel. This is a very easy thing to do. All we're going to need to do here is go ahead and start off with pressing the hamburger icon up in the top left hand corner. It will ask us for our passcode. We go ahead and enter our four digit code. Mine is one, two, three, four. At this point, we are then going to go to devices. At devices, you're going to hit the plus sign up in the top right hand corner. All right, so we're going to be enrolling a flood detector, so you just choose the flood option. Okay, so you turn this over and there's a button down here. See it tells you exactly what you need to do, you just press and hold that down. Okay, so now my water sensor has been enrolled and now wants us to select a location. I'm just going to say patio entry, whatever it is, right? Okay, so she's telling us what to do here. Okay, she's telling you to install it. Once you've installed it, you're going to come back to your panel and all you have to do is just hit done. At that point, it will confirm that your device has been added. At this point, it's good to be mounted. This is how you enroll the device. Now if you want to delete it, it's really just as easy as clicking on the device, going into it and then clicking delete. So it has a toggle. If you just want to make it inactive for a little bit, you plan on re-adding it again at some point. You could just toggle the switch to make it inactive, it'll disable it. But in this case, I am going to delete the sensor. So I just click delete. Okay, the sensor has now been deleted. As you can see, there's nothing left except for the door I have in there and my door bell. So this, ladies and gentlemen, is how you program and delete the GWFD water and freeze detector for the all new Geoalarm system. If you have any questions or any comments, please leave them below. Other than that, take care and have a great day.