 What's up guys got a new toy here. It's called the porta blaster just got this not too long ago They sent it to me cuz kind of curious this thing is pretty light. I mean, it's like two fingers Everything's tucked inside of it. Now as you guys know, I have a Milwaukee transfer pump Well, guess what it's already leaking out of the seal already and I haven't even done nothing It would have caused that so I'm kind of looking forward to using this one because it's got a few features on it That should protect the seals Unlike my Milwaukee that wasn't really built for what I was using it for this right here It's pretty simple as you see and I just put it together and then you got your water line here Got a quick disconnect on there. You've got your outlet so hooks right on to there It's got a little screen on the bottom of it to protect you from sucking things up This is gonna come in handy for today's cleaning cuz I'm doing evaporators inside I don't want to run a hose all the way through the building. This does not run on batteries But I've got the battery pack here from Milwaukee that gives me 120 volts here This thing is so efficient. It can actually run it low power High power this thing only pulls 80 watts and I believe this does a hundred and eighty We're gonna be good to go there So I can carry this thing inside the store and I have to run no extension cord or you can always use your you know Cheaters or whatever it is you've got to do. It's going to get some water in there Shut that thing down in a bucket like that turn this thing on high pressure Pull the trigger and boom Sweet and it shuts off when you're done. So when you want to spray it There's a hundred and hundred and fifty pounds of pressure Drops down to about a hundred and five hundred and ten once running. That's on high. Here's low low drops down to about 70 we've got a adjustable spray pattern if you want to just rent something off that'll work out good there and If you want to go higher pressure, you can go there. This is two coils thick. You got to remember to So I mean it's it's it's making its way through it and then depending on what you're doing like me I'm going to clean off the evaporators inside on the walking cooler Now it gives you a heck of a lot of hose here That's I don't know I'd have to look it up, but I would say it's probably over a bit of 15 foot It's great to talk about things, but I'd rather see things being used. I'm going to run it on low at first So here we are back and come in here with this real fine mist We're not coming in really hard so we're not going to overfill the can. Let's go ahead and do high now We're able to knock those All that crud off with a no problem at all I think the only thing I'm going to change on this I'm gonna get my bending tool out and we'll see if I can't bend this into a 90 because for me I need that that angle so that I can get in there So that would be the only thing I would change on this is put a 90 on it So I can get in there like this because I don't have the room to go at an angle like this very easily Normally these are right up against the wall and you're never going to get into them like this That piece right there is a little too short to be able to bend it there So I'm probably got to bend it an inch down from there All right I do not recommend trying to bend this with your bending tool because it will kink the stainless steel here It's not gonna hurt anything, but it's gonna give me a better 90 if I was really worried about it I could always cut it here here and put a 90 on it and just solder onto it. Not a big deal That's what they did here. You can see that's been soldered on Hey, we got some really misty ice machine here, and I've been scrubbing at it. I've done giving up We're gonna just trash the ice so we put it on low back all over the place It's all that throughout already we're making some progress It's making this a lot easier just by using soapy water and running it right through the machine So it's doing really good job All right. Well, we got it cleaned up ran sanitizer through it got everything out this crap here It's locked on you ain't getting that off even with a thousand pound power washer but it got it cleaned up and we got all that crap out behind the coil and Sanitized it and everything while we're at it. So we're good to go on that Unfortunately, this guy's got really bad water and that's what we got The portablaster there really made this job a lot easier this thing blasted all the nasty crap out and was able to Speed it up a lot easier Pretty impressed with the fact that we got the high and low switch the pump shuts off when you're done with it It's got my recommendation as far as longevity how long it's gonna last. I mean time will tell I've only had it for a short duration of time, but as of right now, it seems to be working really good I ran this thing for probably 25 gallons 30 gallons in my Milwaukee Power supply there still has one bar left. I think I was at three when I started Otherwise you can get the extension cord out. I just didn't want to mess with it hands. I'm out here in a dining room area So guys make sure you check out stuff code tools and until next time we'll catch you on the next one