Loading...

WELD POTMETAL see ebay item # 120767372265 or 261399135665

14,144 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Jan 13, 2008

WELD POTMETAL

We have developed a rod that makes it so easy to weld POT METAL with any kind of torch, that even an amateur can look good even on the very first try.

A propane torch puts out 2600 degrees farenheit. POT METAL melts at a very low temperature.

A propane torch puts out 3 or 4 times the heat it takes to weld POT METAL.
So, we have never had a problem with having enough heat.

We used to have a rod problem. Now we have solved the rod problem.


Just clean your POT METAL down to bare metal. Use a file, grinder, sand paper, sandblast or brush it off. You do not need to use a special stainless steel brush to use our rod.

Just do not use any chemicals.

I will guarantee you that you will not ruin your POT METAL.. You will be a success on your very first try.

We have developed many rod over the years. We have built thousands and thousands of rods in Arkansas, Florida and Texas.

Our rod has the same satisfaction guarantee that we have always had.

You may have seen me demonstrate this rod.

I have demonstrated this rod over much of the United States in the last several years.

You may have seen me at boat shows, car shows, RV shows, antique car shows, tractor shows, and steam shows, in many different states.


Many welders will tell you that it is impossible to weld pot metal.

Antique automobile rebuilders, use my rod to weld grills, tail light bezels, windshield frames, door handles, hood ornaments, and etc.

This is new fresh rod, and the rod will never go bad. There is no flux in or on it, so there is nothing to go bad.

Please do not use any kind of flux, No chemicals. No acid, no jells, no resin of any kind.

Just file, sand, grind, or sandblast down to bare metal, but please do not use any type of chemicals.

You do not have to used a stainless steel brush to use our rod.


You can weld potmetal just as well as I can, but it needs to be with my special alloy rod to be successful.

Full, easy to understand instructions come with each pack.

I sell this rod on ebay with a satisfaction guarantee.




Please look at ebay item # 120767372265 . Put this number into any ebay search box.

or put this number into ebay seach box for wholesale rod 261399135665

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...