Loading...

Link Optimization LigoWave v1

1,676 views

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Oct 27, 2014

► Website: https://www.ligowave.com/
► Facebook: https://www.facebook.com/ligoptp
► Twitter: https://twitter.com/LigoWave
► Google+: https://plus.google.com/+LigoWaveWire...

It is important to optimize your link in order to get the best possible performance.

An optimized link will give you stable throughput and delay.

Due to the nature of the unlicensed frequencies, optimization is an ongoing process.

Configuration:
1. Set the channel width to the lowest available value.
2. Run a spectrum analysis to identify the frequency with the least interference.
Important: The spectrum analysis ha to be performed locally. If you perform the spectrum analysis with a remote station, you will lose the connection with that radio.
3. Configure the frequency with the least noise.
4. Reduce the maximum data rate by 2 modulations in the master slave or both depending on where the noise is.
5. Set the transmit queue length to a value of 8.
6. Run a link test to verify the throughput and packet loss.

Fine tuning
- Reducing the maximum modulation in steps of 1 and perform link tests to validate throughput and packet lost.
- Try different frequencies and verify the throughput results with different modulations.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...