E3 Flasher Limited Edition (for Playstation 3) - Unboxing!





The interactive transcript could not be loaded.



Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Aug 1, 2012

This Ultimate PS3 Downgrade Device - will allow you to downgrade a NOR PS3 from 4.11 to 3.55! You have to make sure the PS3 originally came with 3.55 firmware or lower from factory.

This device is only for consoles with NOR flash, not NAND at the moment. This is a non-solderless jailbreak for slim PS3 models.

Comes with:
- E3 Flasher
- E3 Nor Clip
- Hard Drive Bracket (for the flasher)
- TF Cover Board
- ESATA Station w/ manual
- Phillips Screwdriver
- T8 Torx Security Screwdriver
- Power switch (which is included for free, but I don't recommend using)
- Power cable (EURO format) for ESATA station, you will need converter if you are in north america
- SATA to SATA Cable
- USB 2.0 Cable

Can be purchased off of the MODCHIPCENTRAL website, for about $90 (before taxes and shipping). However, to perform the downgrade, you will need a downgrade dongle that will place the PS3 in service mode.

Here is the link if you wish to buy (MODCHIPCENTRAL is a very reliable site, highly recommend over lightake.com):


Thanks for watching.
Comment, Rate, Subscribe!

Note: You will not require this if your PS3 is already 3.55 and below. If your firmware is above 3.55, this is one of the few methods to jailbreaking your console.


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...