Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Nov 21, 2011
This is my new controller setup for running my 3 axis skulls using the Picaxe. It is a stand alone system and doesn't require programming except for setting the servo limits. Total cost of the components to build the controllers was less than $60. Here's the link to a forum thread discussing the build including the code - http://www.hauntforum.com/showthread.... I got the instructions for the 3 axis from the DVD offered by Halloween2go at http://www.halloween2go.com/volume1p5...