 Welcome to this lathe operations module on tapers with a taper attachment. Setting the taper attachment to cut an accurate taper can be difficult. Once you have initially set up the taper attachment according to the text, the taper attachment setting will need to be refined. There are a number of ways to check the taper bar settings for accuracy. 1. The most common way to check the taper bar setting for accuracy is the trial and error method. Move the carriage 1 to 2 inches to the right of the taper star position. This should be done at every pass to remove the backlash in the taper attachment. Feed the tool into the trial cut depth. Make a 1 inch long trial pass. Check the start and end diameters of the taper at the 1 inch long interval. The difference in the diameters should be the required taper per inch. Move the cross slide extension to the pivot point of the taper bar and adjust the taper attachment accordingly. Note, using a straight edge, check to see that the entire length of the turned area is tapered. There should not be any open space along the straight edge if the entire length is tapered. If the entire length is not tapered, there is still backlash in the taper attachment. Try starting the cutback farther to alleviate all of the backlash. The trial and error method of taper attachment adjusting is acceptable as long as you have plenty of excess stock to work with. Method 2. The dial indicator method is a better method of checking the accuracy of the taper bar setting, especially when there is not an excess amount of surplus stock. Set up a test bar or your workpiece in the machine. Set up a dial indicator on the compound rest or the cross slide extension. Now set up an indicator to measure the amount of carriage movement. Move the carriage until the dial indicator on the compound rest begins to read a consistent amount of travel. Set this indicator to zero. Reset the indicator that is keeping track of carriage movement to zero. Move the carriage 1.00 inch. The reading on the cross slide indicator should be that of the required taper per inch divided by two. If it is not, move the cross slide extension to the pivot point of the taper bar and adjust the taper attachment accordingly. The digital readout is the best method of checking the accuracy of the taper bar setting. Set up the taper attachment according to the taper bar setting. Make sure that the x-axis digital readout is set to diameter rather than radius. Move the carriage until the x-axis readout begins to read a consistent amount of travel. Reset both axis displays to zero. Move the carriage 1.00 inch. Note the x-axis diameter coordinate. When the taper bar is set properly, the x-axis diameter readout over 1 inch of carriage travel should be that of the required taper per inch. You have completed this lathe operations module on tapers with the taper attachment.