 Hey guys, Drew with GeoWarm and I am back to talk to you about the M2M MQ03-LTE and its connection into the DSC EMPASA wireless security system. Super easy to do on this, four wires. So what we're going to do prior to doing anything here is make sure that you've killed power to your system, obviously mine is powered down, but in order to kill power you need to unplug the power supply and then you need to get the panel opened up by going into these two little slots at the very top here and then kind of sliding your flathead screwdriver in and pulling the screen towards you. Once you do that it will pop it open like so and then we can get into it. So once you open it up you'll see the interior of this. We're not going to be worried about this side right now so we're going to put this over to the side here. Once we do that we're going to look inside we're going to see our wiring terminals here and I'm going to go ahead and flip it this way so that you can see it. The battery is disconnected as well so we're powered down. Now we're going to be using these wiring terminals here. Specifically we're going to be using aux plus, aux minus, R and T which stand for ring and tip. So what we're going to do is grab our communicator after the panel's been opened and powered down and as you guys can see I've pre-wired this communicator so it's going to be four connections total. So we have two strips of 22 gauge, two conductor, in this case it's four conductor but I didn't cut these back because I actually I'm going to use this again. So you guys can ignore these connections here only these matter. So the red wire is going to go to plus or positive and the black wire is going to go to minus or negative. By the way you will have to come up with your own wire it does not have a wire and it won't ship with it because no one knows how long the run will be so you will be responsible for getting wire. So we have red to plus, black for minus, then we have red for ring and black for tip. Once you've confirmed those connections you can go ahead and get it wired back to the panel itself. So we'll start with the power connections themselves right now. So we'll take the red wire and that red wire is going to run into aux plus right here and once you're able to slide that in there go ahead and tighten it down once you're able to get it in. Remember you're probably going to want to be just showing you this way for connections are all done then what we're going to do is we're going to go ahead and get the actual communicator put together here. So communicator wired into the panel we need to get our antenna connected which we're going to do like so. There's your connection just go ahead and once you've confirmed that's on you can go ahead and get your antenna out of the way. Now the last thing we have to do is get our internet plugged in which we'll plug in right here as you can see. At this point you are wired in and you are ready to give us a call and get this activated. Go ahead and power your system on. If you guys have any questions or any comments please leave them below. Take care. Make sure to subscribe to our YouTube page and click the show more tab underneath the video where you can view valuable links pertaining to this product, similar how-to videos, and our low-cost no-contract alarm monitoring services.