Loading...

Dog_Clutch for Threading on the Minilathe

11,174 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Apr 7, 2013

A demonstration of the single point dog clutch and the retracting tool holder as used for single point threading on the minilathe.

The dog clutch automatically picks up imperial or metric threads (no threading dial needed) and the auto-stop takes the worry out of stopping at the right point. A runout groove is automatically added unless one retracts the tool holder exactly when the clutch triggers - which would put the challenge back into threading...

Info about the dog clutch:
http://www.gadgetbuilder.com/Dog_Clut...

Info about the retracting tool holder:
http://www.gadgetbuilder.com/ToolHold...

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...