 Here's what one looks like after it's finished Hey, what are we doing? We're making some kiss Stormtrooper Coasters So what happened with these? What do we do? We printed it out and now we cut it It's on super Not super thick mid-range thickness paper. It's premium matte paper Really a matte paper and then we cut it out with an exacter blade looks like that But it's a part with a handle Then we use spray adhesive this particular ones by Krylon You should wear any kind of mask or respirator when you're using aerosols and be in a ventilated room We have all the fans and vents on Air dry it for just a second These we only prepped them by spray painting them. They're just white Hexagonal Pentagon no pen is fine. Hex is six right. I'm pretty sure we're gonna go with that Shape coasters Well, they're tiles, so we're gonna use them for coasters This is a super Easy-ish DIY if you need something for Christmas or A birthday or an anniversary and you just want to make something instead of spend money You don't want to dampen them You don't want them to like bubble up and stuff, but you need to definitely give enough to wear They're not gonna move once you apply the resin to the tops of them We also like to do these on these lifted Situation home rigs It's just a painting stick and spray paint cap We'll check for our levelness Before we pour the resin. Yeah Because we're gonna be able to level these. Yeah, we are Purple guys my favorite Arotex light we use this for almost all of our resin products. However We did just get some of this and a lot of people that like cast or dependents Use this, but it also says that it's FDA compliant, which I'm pretty fairly for sure that means It's safer for anything that's gonna be around edibles yet being used as a cheeseboard so when we go to Baltimore next month to do those countertops will probably end up using that depending on This stress test that we have to do Dollup in the middle that we're going to spread to the outside edges I mess with it as little as possible. So as soon as you can don't touch where You can call it a decal because you don't want to risk the ink moving or the edges coming up and Floating to the top of your resin even if it's not done on white But we use the standard spray paint in matte black to change the color. You can obviously use any color That probably will work the best most a whole one of those ounce cups So that's about two-thirds of a one ounce cup So you can also when the bubbles are bigger like this one this bubble right here You can blow it to get it to pop It's not always best to use heat to pop the big bubbles, especially when you have like a decal or print under it You want to keep the resin as thick as possible So that it doesn't overflow and leave you with weird ridges around where your print is So we're just gonna let these set for a minute and revisit Probably every 20 minutes to make sure these aren't here and pop them So here are the final final sets Super smooth no lines All the bubbles popped only thing that we're gonna have to do with these guys is Sand the back on a couple of them because When we added extra layers of resin to make sure there wasn't an edge We did not remember to scrape the bottom so we're gonna have to sand that off And some of them took some wood from our Or what you call it So we're going to sand that off Not all of them had sketchy bottoms. Some of them came off relatively clean, but Happy with them. They are going in a show tonight