YouTube home National Registration Day


rear brake pad replacement with picture for 1990,1991,1992,1993,1994 toyota camry





Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Aug 20, 2011

visit us on

Brake Pad: Rear

NOTE: If a squealing noise occurs from the brakes while driving, check the pad wear indicator. If there are traces of the indicator contacting the rotor disc, the brake pad should be replaced.

-Remove rear wheel

-Temporarily fasten the rotor disc with the hub nuts.

-Check the pad thickness through the cylinder inspection hole and replace pads if not within specification.
Minimum thickness: 1.0 mm (0.039 in.)

-Remove the installation bolt from the torque plate.

-Remove the brake cylinder and suspend it so the hose is not stretched.

NOTE: Do not disconnect the brake hose.

-Remove following parts:

-Two brake pads -Three anti-squeal shims -Four pad support plates

-Check rotor disc thickness

-Check rotor disc runout

-Install the four pad support plates.

-Install the three anti-squeal shims to the pads.

NOTE: Apply disc brake grease to the both side of the inner anti

-squeal shim.

-Install the two pads so the wear indicator plate is at the bottom side.

CAUTION: Do not allow oil or grease to get on the rubbing face.

-Install caliper

-Draw out a small amount of brake fluid from the reservoir.

-Press in piston with a hammer handle or an equivalent.

NOTE: Always change the pads on one wheel at a time as there is a possibility of the opposite piston flying out.

-Insert the brake cylinder carefully so the boot is not wedged.

-Install and torque the installation bolt.
Torque: 20 Nm (14 ft lb)

-Install rear wheel -Fill brake fluid


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...