==Update 9/29/14== Gang - I've been AFK from the scene to tend to my newborn. Can't miss those special moments right!? I never could have imagined this video would be as well traveled as it has been so thank you all for the comments & feedback (good and bad). I'll be returning to "the scene" in due time - just please remember to fly safely! Our hobby is under a lot of scrutiny right now - so no news appearances please!
==Update 2/16== KV OSD Setup guide HERE http://www.youtube.com/watch?v=ikKH_6...
*** watch on a computer so you can see the annotations!
*** Another big update - in the time since I've recorded this video - GPS_HOME and GPS_HOLD flight modes have been added. I'm going to let that sink in for a moment ...
This is a HUGE development - UPDATE YOUR FIRMWARE TO THE LATEST HEX!!!!
***
This was a special request from some of the new pilots flying with us. We're in the process of building out more than a dozen micro FPV quadcopters and will be using the Naze32 controllers to run the rigs.
Don't let the length of the "guide" fool you - this is a stupid simple board to set up if you can follow directions. You can get a multi flying in less than 5 minutes if you know what you're looking for.
If you decide to skip ahead or skip over any of the safety warnings - please remember:
*** TAKE YOUR PROPELLERS OFF *** while working with the rig.
You've been warned.
==Index==
0:22 Commentary
4:00 Hardware Overview
7:00 Pin Assignments
19:00 CPPM Connections example
21:45 Accelerometer Calibration - Initial setup
23:24 Magnetometer Calibration
24:20 Magnetic Declination Offsets
25:45 CLI Overview - enabling / disabling "features"
29:55 Radio/Receiver Setup
25:25 Auxiliary Configuration - setting flight modes
38:12 Motor/Servo Outputs Test Tool
40:35 Calibrating all 4 ESCs simultaneously using mincommand
42:40 Commentary, CLI redux, mixer, map & set commands
47:00 PIDs
48:20 Where to buy
CLI Parameter definitions and their suggested settings can be found here:
https://code.google.com/p/afrodevices...
Please fly safely!
