Upload

Loading...

Skeletor

774 views

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Oct 21, 2012

Finished up the project more quickly than I expected; the hardest part was getting the LED matrices to stick to the back side of the skull's "eyes" (using double-sided adhesive sheeting). The prototype was using an Arduino Duemilanove but I moved the sketch over to an Ardweeny so that everything would fit inside the skull.

These displays are *bright*; I have them dimmed down a bit via the setBrightness() construct but they start to flicker past a certain dimming point.

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...