 The Dyna-Coil is a concentrate adapter designed to hold solid and semi-solid concentrates for the VapCap vaporizer. The Dyna-Coil is made for one single piece of medical grade titanium and features a shark tooth pattern designed to catch and retain the concentrates. The Dyna-Coil is compatible with all VapCap tips. To load, first remove the screen from your tip. Insert the coil into the tip with the letters up. Grasp the coil lightly and give it a slight clockwise twist. When installed correctly, you will be able to see through the coil and the cap will not touch the coil. When heating for the first time, make sure you hold your VapCap in an upright position so your concentrates melt into the coils, not the cap. To heat, hold your torch lighter at a slight angle and brush the flame across the tip as you roll the VapCap. Heating lower on the cap will produce a slightly higher temperature, allowing the concentrates to melt. For subsequent heating cycles, heat in the center or the top of the cap. To remove your coil, use the condenser to push it out. Make sure to place your hand on the front of the tip so your coil doesn't go flying. To clean your Dyna-Coil, place it back into its container, add some cleaning solvent, and give it a shake. We don't recommend unwinding your Dyna-Coil for cleaning. We hope you enjoyed this quick video on the Dyna-Coil. Please check out our other videos for more information.