 Today I sanded this cover part here, and it came out not bad Still I want to make sure I'm Neater about my next parts, so I don't have such a messy sanding job Where I end up having holes. I'm gonna have to fill in and stuff So I started working on the chair today After like an hour of trying to get one sheet to come in like this just make the whole thing like curvy I just cut it up into three pieces So I could actually get it lined up exactly where I want it to be So first I just put this piece in and put a tiny bit of resin along the seam Then I put that piece in and put a tiny bit of resin on the seam and then put that piece in and then put it put a bit of resin in and A couple little tiny strips of fiberglass just to keep it all in position Beauty I got some fiberglass over all this up here did extra on the seams Even got behind the chair So yeah, and then I did a seam all along here So this chamber here should be pretty much airtight now It's probably a little hole somewhere That's fine because air needs to escape Right now anyway while it's curing I'm thinking I'll put a hole in this somewhere and then stuff it with Styrofoam and then plug it again And the motor goes right here. That looks like it should be well out of any water Yeah Nice and sturdy too. Yeah And then the pipe for the pedals I don't want to touch that yet because this is still curing I probably want to put a little more around that just to make sure it doesn't move I wonder if I can do this. Can do this. Yeah Years ago. I bought ten of these stainless steel ball bearings Not knowing what I was gonna do with them. I was just like I'm I'm gonna need these for something To these and stick them on a bolt They are the the bearings They will hold this gear against the teeth Yeah, I think I'm probably gonna use that and they're pretty small too, so they won't take a much space Like it what dinner right up to this chair, and then I'll cut that to match Front stuck in I already got that tacked in and that tacked in oh it's starting to look like an actual thing Whoa, I just went fiber crazy Got all that fiberglassed in and this Right now. There's no way to get into this section here or into the trunk back there I'll have to cut the doors It's only two layers of fiberglass on there. It's pretty strong. I might just leave it at two layers Keep it nice and light Hey, hey, baby. Are you a baby? Can I get some smile? I Okay, don't say I am a baby. I am a baby