Loading...

#324 1st burn of Rocket Stove!

137,885 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jan 21, 2013

The wood burning Rocket Stove is done and it works beautifully! This is a complete walk through of my design and fabulously successful first burn. After 5 minutes there was no smoke. When it was done there was virtually no ash. Watch for plans to replicate at http://alt-nrg.org/

Here are the critical numbers...
* Tank is a salvaged 17gal compressor tank with 1/8" thick walls, 36" long by 12" I.D.
* Vertical flue stack is 3 groups of 9" long fire brick, 3.5"x3.5"x27" (12.25 sq-in across, about the same as a 4" round pipe).
* Vertical stack surrounded by 8" x 24" galvanized pipe with insulation stuffed in the open spaces.
* Gap at the top of the internal flue is 2" from the center of the tank (A little less at the edges because of the convex surface).
* Gap between the 8" pipe and I.D. of the tank is 2".
* The horizontal burn tunnel is 5.5" long (measured at the top edges), 3.5"W x 3.25" H (11.375 sq-in across).
* Vertical feed tube is 3.5"W x 3.25"D x 7.75"H (measured from the top edge to bottom inside).

Many thanks to my Justin.tv regular nerd herd who helped greatly with small tips and suggestions along the way. Tippy4u, Critterwindow, Shubus, Adirondacks4me, Lwblack, Kane48, Outsider007 and many others.

To donate directly to my work please use https://www.paypal.com/cgi-bin/webscr... or visit http://alt-nrg.org/ and click the Donate button.

Loading...

Advertisement
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...