 Hey everyone, we are back and we are going to show you how to install the Geo VDBC for the Geo Alarm System. As you can see we've already pre-run the wire here. More than likely at your home it will represent just like this with the wire already pulled so you're just going to be removing a doorbell and basically installing the new one. Our technician Sal here is showing you how to pre-drill the holes. He marked these spots off from putting the back plate on the wall and then just putting a pencil mark where he wanted the holes to be according to the back plate. Very, very easy to do. He's pre-drilling here. Obviously before you do this you need to make sure that you're doing this in a spot that is okay to do it if you are doing this new. Otherwise if this is just a replacement it's just as easy as swapping it out with the new one. Which is why we didn't show you how to run the wire here. Running the wire would be something that's a little more specialized based on the home. As you can see after pre-drilling the holes he put the anchors in now he's just stripping some wire back to expose the copper a little bit further so that we can get solid connections. He's now attaching the wiring to the back plate here. That is how the doorbell will get power is actually through the back plate it has two connections and he's going to show you here how he got those connected once he puts it in. So he's back feeding the wire back into the wall a little bit now so that he can get a flat connection to the wall. And as you can see there the wires are both in both the red and the black wire. He's going to go ahead and tighten the screws into the anchors now so that we can secure that back plate to have it ready for the doorbell to be mounted to it. As you can see it's very very sturdy when you put it in there it doesn't move so it's going to be very secure for weather and things like that. As you can see he's showing you how to put it in. You start from the top and then you snap it in at the bottom and then there's a little screw underneath the doorbell camera that you're going to need to tighten down like so. And just like that the doorbell is installed and ready for use. If you have any questions or comments please leave them below. Take care and have a good day. Please like and subscribe to our page for helpful programming and installation videos, product reviews, monitoring, products and more. Visit www.gawarm.com or call 877-443-6276 that's www.g-e-o-a-r-m.com or 877-443-6276, Gawarm, the worldwide leader in DIY security.