Loading...

HHO 13 plate dry cell, 5v conditioning

4,602 views

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Aug 14, 2010

This is my 13 plate ( -nn+nn-nn+nn-) dry cell. I used Lowes 304 stainless blank switch plates. I modified them by sawing off the ends length wise, and flattening them. I bored the holes to 5/16 diameter. I used .045 contact shelf material as gasket. On the neutral plates I cut off two corners at a 45 degree angle. On the voltage plates I only cut off one corner at 45 degrees. I then drilled the holes for the brass connecting bolt in the remaining corner. For the end caps I'm using a cheap cutting board I found at Big Lots. I have a dual bubbler set up( cheap ziploc containers) with a hydrostatic connection. I don't have it connected in this video. I'm just using the one bubbler. I am only conditioning the cell in this video. I am using 5 volts with 2 tsps of sodium hydroxide to a gallon of water. I'm using my computer power supply that I converted into a Lab power supply. Thanks for watching. Sorry about the lighting. I think that's House on the TV that you hear in the background :)

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...