Upload

Loading...

octocup printing 2

301 views

Loading...

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Uploaded on Jul 23, 2011

Printed on an Orca with 1,75mm filament @35mm/s
with skeinforge support (density 1.0; flowrate 0.9; gap 1.0; exterior only; minimum angle 50°)
http://cunicode.com/octocup-reprap/
--
During the bootcamp-fablab in Barcelona
http://flic.kr/s/aHsjvsT6vs

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...