 In this video, I'm going to demonstrate using the Dyna-Coil with the Bee, a fantastic combination that allows for a tremendous amount of control and ease of use. Effectively, kind of like a dab kit, all you need is the Bee, the Dyna-Coil, some of your favorite concentrate, and something to make it hot, which can be an induction heater, a lighter, or whatever your choice of heat source might happen to be. To begin, remove the cap, pop off the tip, push the condenser out, like this. We take the condenser, and we're going to pop the CCD out of the tip. Next, take the Dyna-Coil, T-side facing out, and occasionally, there's a little edge or corner right here that we can bend out just a little bit to help for a nice snug fit when we press it into the tip. Press it into the tip like this, and press until you feel it kind of click into place. It should hold in place and not fall out. Next, we'll just reassemble our Bee. What we're going to do is we're going to preheat this tip by aiming our flame right at this fin, not at the coil, at the fin. We're trying to preheat the chamber in the tip. The coil will get heated indirectly. We don't want it super hot. We want it warm enough to melt the concentrates, and that's it. About this long to kind of preheat the tip, and now we're going to dip into the concentrate and let the warm coil just simply melt in. And then what you'll see is it melts in. It soaks in to all the pores and surface area in the Dyna-Coil. It's now ready. We cap it off. We finish heating, preferably below the base to go to space. And when it clicks, it's ready. In conclusion, the Bee with the Dyna-Coil is a very simple, easy, and rather mess-free way to enjoy your DynaVap with some concentrates without the need for tools, etc. Tasty.