 Hey everyone, Drew with GeoArm and I am back to talk to you about mounting the panel to the back plate and getting it powered on. As you can see, our technician Sal here is pointing out where you need to be hooking in your power supply. That will come with the Geo Alarm. It slides in just like that, mostly like a, you know, like how a phone charger or something would go in. But it plugs right into the main panel itself. He's wiggling it out there and showing you again exactly where it goes. Obviously you need to make sure that the battery as well is already plugged in. Make sure it's snapped in. So what you want to do usually is just go up there and like, just press on the clip there, slide it up into the up position and it should clip in place. And this point he's going ahead and he's putting the back piece onto the panel itself. It comes with a screw that you're going to have to put into the actual back plate itself so that it'll hold it in place. He's going to do that here for you. You'll get that put in place and you can kind of see exactly where he's doing that here. Once that's in place, it's literally as easy as sliding it onto the three clips that are located on the back plate itself. And it goes in from top to bottom. So what you'll do is you'll slide it in from the top and then just push down and it slides right into the slots. Once you've done that, it sits firmly. If you have not seen how to mount the back plate yet, please check our other video. There is a specific video that I'll include a link of in this video to get that back plate mounted. At this point, plug it in and you should have power. Please like and subscribe to our page for helpful programming and installation videos, product reviews, monitoring, products and more. www.gawarm.com or call 877-443-6276. That's www.g-e-o-a-r-m.com or 877-443-6276. Gawarm, the worldwide leader in DIY security.