 Next to the Run Validation button, you will see two additional buttons, Complete and Incomplete. Currently, Incomplete is grayed out. These buttons contribute to the reporting rate summaries that we can access, either within the reporting rates module of the reports application, or within any of our other analysis applications. If I click on Complete, it will give me a prompt asking us, are you sure this data set is complete? We'll click on OK, and it will run the validation rules. We might want to fix this data whenever it prompts us that these rules have been violated. Notice now at the bottom that Complete is grayed out, and Incomplete can be selected. By clicking on Complete, when I run my reporting rate completeness, this data set will be considered complete and contribute to my overall reporting rate. I can go ahead and click on Incomplete. It will then give us a prompt to say, are you sure you want to remove this data set's completion status? If we click on OK, then this data set for this particular period will no longer contribute to my reporting rate completion. We'll just click on Complete again, and we'll reload the data set. We'll select the same data set and period, and we'll just scroll down to the bottom. Here at the bottom, you can now see who completed the data set and when they completed it. You can click on See Details to see additional details about that user. This will allow you to contact them directly if required to follow up on any of the information that's been entered.