 So I tried firing it up. I got it fired up for it ran for about a minute and So I was kind of going through everything. I thought maybe I needed to tweak the carb. I think the carb is good So I pulled out the spark plug Initially, I had spark before I put the plug in and now it sparks once when I hit the key and It doesn't spark after that. So This thing has a lot of rust on it When the ground's like to rust You won't get a decent spark. So as you can see there's some rust there Ground wires right here. I went clean that up Make sure I had a decent ground going to the block what it was doing is it would spark on the first try and Then it would spark afterwards Some of the issues with these are the kill switch. So there is a black wire There's a black wire those right here and Plugs into the kill switch Right there Just unplug that And it'll get spark And I'll show you what I got It's basically your bypassing the kill switch And now when I go hit the key I should have spark Turn on This on some metal if you can see that in the camera, but I got lots of spark now Before I hit the key. I only got one initial spark Motor would turn over and then I had no spark afterwards not a bypass kill switch And I got plenty of spark Give that a shot. That's a quick fix until you can figure out what's really going on So I'll give you a quick tip until next time