 Hey what's up folks, in this video we're taking a look at the Adafruit TFT feather with the ESP32S2. This dev board features a 1.14 inch display with a LiPo charging circuit and battery monitor. It's got the ESP32S2 mini module that works with both Arduino or circuit Python. We designed and 3D printed a snap fit case to make a little compact IoT project. We can easily add STEMIQT breakouts like these temperature and humidity sensors. The two buttons on the front are accessible so you can quickly reboot or get into the bootloader. You can get the parts to build this project, links are in the description. You can 3D print the parts without any support material using your favorite filament. The bottom features slots so you can use M25 hardware to secure the STEMIQT sensors. You can fit up to two boards and secure them using hex nuts. A small lipo battery is able to fit in between the standoffs with the cable routed through the side. The feather press fits into the case and these two covers just snap fit over the top. The STEMIQT connector is accessible so you can daisy change your sensors and make a portable IoT project. We hope this inspires you to check out the new TFT feather with the ESP32S2. Thanks for watching and be sure to subscribe for more project videos from Adafruit.