 Hey what's up folks, in this project we're making a festive ornament with the Adafruit Circuit Playground Bluefruit. This is a 3D printed ornament inspired by the Green Goblin's pumpkin props. Inside the ornament is the Circuit Playground Bluefruit with a 16 Neopixel ring and a 500 mAh LiPo battery. This uses the LED animation library for Circuit Python, making it really easy to animate Neopixels. With Circuit Python, the Circuit Playground Bluefruit shows up like a USB drive so you can easily access the code in libraries. With the animation group module, you can animate multiple Neopixel objects so you can animate them independently to make really cool effects. Circuit Python makes iteration much faster so you can experiment quicker and focus more on your creativity. This DIY ornament kit is the perfect size for fitting the Circuit Playground Bluefruit and the Neopixel ring. Our 3D printed mount makes it easy to snap fit the Neopixel ring to the back of the Circuit Playground Bluefruit. We used short silicone wires to connect the Neopixel ring to the large pads on the Circuit Playground Bluefruit. Be sure to check out the Learn Guide on the Adafruit Learning System. The wiring is fitted through the slit in the 3D printed mount and the ring snap fits into the recess on the back. The LiPo battery gets sandwiched in between the Neopixel ring and the Circuit Playground. The mount has these little tabs that keep the PCB in place without any screws. The battery can then be connected to the Circuit Playground Bluefruit. The diffusion material like parchment paper is added to the DIY ornament so the Neopixel LEDs are nicely diffused. The DIY ornament is fitted into the 3D printed halves and they both just snap fit together. We hope this inspires you to try out the LED animation library for your next Neopixel project. Thanks so much for watching and be sure to subscribe for more projects from Adafruit.