Loading...

Duratrax Evader EXT2 - Going Brushless video #3

6,272 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jan 10, 2012

This is a quick video of a few runs before and after installing a Tacon 3930Kv Brushless RC Motor. I am using a Castle Mamba Max ESC and I have already upgraded the Tranny gears to hardened metal and replaced the stock plastic Differential with the metal version. I'm curently running a stock 88t spur gear that I will be replacing soon. I could not get top speed readings today but I see what I can do about that soon. The biggest differences between the two setups so far is the torque and top end. I am only running a 8.4 volt battery pack so there is plenty of speed left in this new brushless setup. I just need to re-gear and get some 3S Li-POs in it. Thanks for checking out my videos, if you are looking for any part numbers of what I have used then check out my website, I have them listed on my Duratrax EXT2 page. www.brushlessrcmotor.com

Loading...

When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...