 Hey, it's Ellie Hart from TC Helicon, and this is the Perform VK video manual. So we've got our mic stand mounted, multi effects processor, mounted onto our mic stand. Whew, got it out. The first thing we're going to do is we're going to start plugging stuff into it. So let's go over the back panel. We have our mic in, which I have located right here. So I've got that plugged into the mic down this beautiful blue XLR cable, and we're going to put that right into the mic in. Next over we have our instrument ends. So I've got this keyboard here. I've got my instrument in here, it's a quarter inch TRS cable, and I'm going to put that into the top one. Next is we have our instrument out, and this is what's going to send our vocal mix and instrument mix to the PA. So I'm using a little monitor speaker, and I'm going to send it to that, but you could also send it to a house PA wherever it is that you're sending your audio. So here we have this cable. You can see it's going all the way into the speaker through the quarter inch jack. So we're just going to plug that in right here to the left input. So that's your instrument out. Next here we have aux. This is an eighth inch jack input. So you can put an iPad or an iPhone or any mobile device. You can even use it for an instrument if you don't have either MIDI or a quarter inch instrument out, and you can put that into the aux there. The other thing that this aux in is really helpful for is if you want to do a metronome or a drum machine, lots of different options. We have another segment called aux audio. So there's a lot more information within that segment of this video playlist. So go check out that one for a little more info on that. And then we've got, it says pedal here. This is for a switch three or a switch six pedal that we sell separately. These are really great. They allow you to trigger any of the effects on the performed VK with your feet from the floor. So they're sold separately. There's a switch three, and the switch six has six switches on it. So these come with a TRS cable, tip ring sleeve. Very important that you either use the one in the box or if you need to replace it, make sure you get a TRS cable because it will not work with a TS cable. That goes in there onto the floor and this end goes into that pedal input. And we have our MIDI. So I'm going to be using a MIDI signal from this keyboard, but you could also take MIDI from a laptop if you're using a DAW or from a MIDI controller or whatever it is, MIDI in, as long as it's sending, this will be receiving. So I now have my MIDI and an aux and an instrument in. When using harmony on this, just so that you know, it's always going to prioritize MIDI and then instrument and then aux. Okay. Next, we have a USB port, and that's for doing your firmware update. You can also import some presets from our app on a mobile device. So you can plug them in for that. Or you can do USB audio interfacing or recording with it as well. And that can be done through that USB. So very handy little port. And then last but not least, we have our power, which I have here somewhere. So 12 volt power comes with it. And that just goes into the back there. And that also turns on the Perform VK. You can see it power cycling on there. Voila. We have power. We did it, guys. So that's the Perform VK all set up and ready to go. If you have any questions, please throw those in the comments below. If you like this video, you found it helpful. Throw a little thumbs up over there. And please subscribe to our channel. Thank you.