 You see the two parts, so it finished the pin and it moved down to the base. But the one thing that has me concerned here is if you look on the left portion here, it's starting to split from the bed a little bit. You can see it rising up. In here the slicer actually recommended that I use brim for this part and I chose to override it. I thought it would be fine and I'm regretting that decision right now. So I end up just cancelling this print and then resending with the part by itself with a brim enabled. Since I went with the print sequential option, I don't end up losing the pin since it's already finished printing that part. I've got the rack printing on the mini and the first layer is looking excellent. And moving on to the mark 4, I've got the spur gear. And here I'm running the mark 4 with input shaping enabled so you can see here how that looks.