 busy morning of demolition not standing this morning it's five to eleven there you go great tool and there there's the blade of a Nassabao it's actually blue when it comes there you go quarter past six but there's the nasty fan out you see the insulation for where Alex has built the other side plenty of insulation in there that's just a 320 mil piece straight in so busy morning of demolition not standing this morning it's five to eleven so that's done we didn't do that yesterday door came out in one piece no damage for all those people who keep telling us we should save this shite if it stays a bit customer said it's knackered and it's going in the script so we took it out carefully to give them the option so there we go all the two that two of them was done yesterday that's put them come back to that yeah again cavity has been cleared out always do that so we've got straight wall through now and then we'll be building up to here cross getting that window against that side putting that in fixing it to this side and then building this side up this side again cleared the cavity out and because we had a no framing the way no bit work got this beauty on it I bet that took ten minutes to do all them look how clean clean it does it there you go great tool and there there's the blade of it's actually blue and it comes there you go expert carbide tip and this this is sander cement it's not that strong and it tore through it and I didn't think it would on this and cement but it's done well save so much time that so little dust some so much time saved so yeah these are three-quarters here these so judging when we see what we've got across here they could be coming out oh yeah as well we took the four piles up which came up to the door and then we had plastic put in the cavity and it's filled with sander cement they could come over the top because obviously they haven't formed the door like we do there's the stuff out the cavity it's done right but like the put plastic because it's very damp down there but it should that pretty much shouldn't be there the floor should come up to the skin but obviously this is like it's gotta be the 60s this was built they haven't even used block slum any old brick on the inside so yeah quick tidy up load out and then I'm gonna get this block working first this block working first and then jump on the brick by that time Alex should be finished around here he's cracking on here there you go course and a half to go made a lovely job of that so yeah once you dropped off there you can tidy that up and you can start tidying all this up while I crack on with this so it's a like a 65 to 11 all the demolition is done now so we can start putting things back together it's a favorite bit so yeah back on the old time that's where I get makes a sense of all this I'm catching a bit tidied up all bagged up ready to go once Alex has done his scuff you can get around with the bar and that's then I'll snow me all this for me got everything cleaned out might be gauge up as usual just working out the cuts I'm gonna do all the cuts to grind the evolution as usual that's done so I just build it a pillar here probably just I think it's slightly less than a block so we'll just put block on block a little bit put some screw ties in there is our tie wire there's our screw ties insulation in the garage in that brick jacket bag there yeah I'm just waiting to drill the screw ties I'm gonna get Alex with the evolution Hoover so when I was drilling you can put the Hoover underneath so stop the dust blowing back in the kitchen as it's quite it's it's tidy but it's tidy as we can get it anyway yeah here's one of those things you have to look out for an extensions damp course level this is Adagrano a scraper on top probably about 20 mil so don't assume damp course is your floor level that's about 20 mil above so we did make that mistake on the last one it costs us a lot of time so I won't be making that mistake ever again I'll be checking that on every time on every job but yeah I'm ready to get cracking now so I'll try and get some block working before lunch here we go progress update Alex is gonna go and do that for me the block that I missed it's a 310 on edge and it fits straight in I've smashed up the like the extractor thrown that away and just isolated the wire don't think it's live anyway but I've just taken it all up so it's safe these are our cuts for here because this is where we come up to with the window so it's just a block on block all the way there with the ties in we've we had we have 50 mil installation when we do cavitt lentils because nine times out of ten they're all properties with 50 mil cavities but on this house for some reason it's a 65 mil cavity notice the the user a brick as a closure so we just had enough for the 50 to keep it as 50 but it was rattling round a bit so I've just nipped off instead of just doing the bit minimum I've just knitted off the berries and got another full pack of another full pack of 50 mil so we're doubling it up so that's nice hundred million there makes them warm and do the same up there when we do that one and that side's already done so yeah inside's done it's a bit tidied up in there that just needs doing I'll probably grab him while he's in there passing the stuff in and oh yeah you can make me a brew while he's in there as well so it's just gone about ten past two so it's going to be a bit of a push but we'll get it done we're going to wipe the window in as soon as we get up to height we've got a nice solid bit for the window to sit on this side and then we're going to fix it in that side with two grabbers and then we're going to put two screws into this side of the frame sticking out into our brickwork so we can build them in we're not going to seal it because our seal isn't very good so we'll probably leave that for the kitchen fitter to do they're probably a lot better with the seal than we are so yeah that's it Alex has just got those up I got the up to damp and then he's just put those few in for me while I've just nicked to berries took me to any form in its round trip it's only about two miles down the road it's just getting through all the traffic lights but yeah I'm going to get this whacked up now and as soon as we get to there the wind is going in so I'll put you on time ups again and while I'm doing this Alex is going to have a good tidy up I've got a few block left over and a few brick so we'll ask the customer if they want some leaving for any other patch jobs oh yeah a quick one talking to patch jobs made a lovely job of that I'll I probably helped them for the middle half dozen courses but he's done the rest of it on his own which is great because he doesn't get a lot of chance to get on the trail so he does a lovely job of that nice match and while he was there we had one of these here so we should whip that out as well but this one we don't want to start messing with this because this is a gas pipe so we don't be swinging hammers and power tools around this so unfortunately we can't do that today we just don't know a skit so yeah there you go the worst ones done the more obvious one the other ones not so bad but yeah there you go as you if you remember that used to be a render 1200 window with the 1200 render panel underneath it which is now over here as he said customers are getting a skit for the kitchen when the kitchen comes out so this will all go in there we've got plenty of food bags so yeah I'm going up around here this is just all needs a rub down it all yet because that was pointing quite wet last night it's all going to rub it off later get all the snobs off so set it up again and let's get this wiped up quarter past six but sorry about that we're done that is one window completely patched up and shifted over to here yeah plus a bit of patching yeah plus a bit of patching and a window moved in a door bricked up and the little patching up I was going to do this one but as you can see it's way too close to that gas pipe I don't want to I don't want to mess with that that was already as struggle as it was trying to get this brick in through pipe but there's my part and there's dad's part and obviously like dad said we fitted that window into which wasn't easy consumed a good half an hour but the main thing is we're done just as it's starting to really come down on us so we'll get tidied up and whatever yeah I'll try and do an outro I've still got some will to live let's go to go over this so returning but that is the end of this little two-day job if you enjoyed it be sure to give it a thumbs up and if you want new to the channel you want to see more stuff like this and everything else we do lentils extension patching up garage conversions be sure to subscribe and tap on that bell that way you'll always be notified when we upload our next videos that's always a massive help and we always greatly appreciate the support you guys give us this has been a very wet and fed up Steven Alex and we will catch you in the next video