 Now let us see how to add static routes in a router now. I know that this interface is This interface is gigabit zero slash zero Which has the IP address of the series 10 dot 10 and since I want all the traffic generated from these network to Be forwarded on that board. What I'm doing is I am specifying that zero This is a representative for all the IP addresses that is network traffic generated from all the IP addresses and This is the This is the generic mask Now this should go to the 10 series network so I Specified the next hop as 10 series network the network address of that and then I'm going to add now we have a static route called 0.0.0.0 slash 0 via this port it has been added without This static route if I try to send a packet from this to Say this it would fail as it can be seen here from the status now I'll try I'll add the route Now let me try to send a packet and see that it is successful because Now there was a now there is a route between these two devices We just saw how switches are sending packets from source to the nearest routers and how routers direct those packets to its destination to the router nearest to its destination And to do so we saw that each router has something called the routing table And using the routing table the router is able to determine on which interface the packet is supposed to leave Now this is the correct time for a quiz