Loading...

Oxy Acetylene Welding | Gas Welding | Adjusting The Flame

203,725 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Feb 1, 2013

http://bit.ly/VAj0py When oxy acetylene welding you must keep two things in mind when adjusting the flame: 1) How much gas is going through the tip. 2) The relationship between oxygen and acetylene. If you have a tiny flame you wont have proper gas flow for a cooling effect. A big flame will cause localized overheating. Both cause torch to pop and blows out the puddle. This videos discusses this, and shows you how to adjust the flame properly - how to form a nice sharp cone. Get the entire Oxy Acetylene Welding DVD here: http://www.wcwelding.com/oxy-acetylen...

Loading...

Advertisement
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...