 Welcome to BCH Technologies. This is Kevin. Today we're going to show you how to reset the waste tank. We'll reset those using T6711 series. There are lots of printers using this waste tank. For example, the eco tank series to remove the waste tank is very easy. So you just remove this tree, put it here, and then pull it out. The workforce WF-7620. And we have those workforce where those guys have to take this out and then remove it. We're going to use this mb5. Okay, you can get this resetter by going to bchtechnologies.com and go to accessories and resetter and resetter for the waste tank. Today we're talking about the mb5 that can reset the 6711 or 617. You can see we got a one-star review of two stars. And basically it works for his 716. However, he complains about he don't know how to line it up. And this is why we make this video and show you how to line it up. I hope after you like this video and you make work, I hope you can come by and give us five stars. So when you pull it out, you can take a physical inspection of this. Basically, this just hold the ink. The one we need to reset is this chip. Then you have the dilemma here. So you get four pins on the top and three pins on the bottom. And this little thing is triggered when the resetter going to put electricity on the pin. So when you push, it will light up. Because now it cannot reset, so it end up with a red light. So how can you reset? There are five pins on top and there are four pins on the bottom. How can you reset it with four pins on the top and three pins on the bottom? The trick is you skip the first pin. So the top left pin will never be used. And the bottom left pin will not be used. So you line up to the right. And this time I didn't line up. Let's try again. Okay, first one. Second one.