 Hello everyone, Drew with GeoArm and I am back to talk to you about the Geo Alarm System and how to program in the Geo-GBD Wireless Encrypted Glass Break Detector. It's not that difficult, the system is pretty intuitive and intelligent so it pretty much walks you through exactly what you need to do. So we're going to go ahead and hit this button up in the top left hand corner. You're going to enter your master code, which factory should be 1234. Once that's done, you're going to go into devices. Then you're going to hit the plus sign on the right hand side of the screen. Choose the device that you want to add, as she just said, and we're going to choose glass break. Okay, so you're going to press this little button that's located right over here. It's kind of difficult to see it, but it's a little circle right next to the light that's in the middle. So we press that down, it should trigger. Now it's enrolled in there, you choose the location of this device. I'm going to say it's the family room glass break. Not going to be installed anywhere, because I'm just showing you how to program it. But if it was, and I completed it, I would hit done down here. Okay, so it tells you now that there's a glass break enrolled in here. We can click that and then click there, custom name it, you can do so. It's an instantly triggered device, meaning as soon as it picks up glass break it's going to go. There's an about section, it will give you the signal strength as well, and then obviously a delete. I'm going to go ahead and remove it because I need it for any of the following videos, but if you had additional sensors to enroll you could keep doing so, but don't forget to visit www.gorm.com, that's www.g-e-o-a-r-m.com for new parts, low cost month to month monitoring, product manuals and support, alarm certificates and update forms, and many others. GeoArm, the worldwide leader in DIY security.