 Setting up your bamboo printer in under one minute. Remove it from the box just like this and then grab the hex wrench from this cardboard box right here. You're going to remove screws from anywhere you see a red arrow. Start with the front and then move on to the inside, remove this plastic piece along with some extra beds. Leave that foam piece there for now. So next we're going to attach the screen just like that. And then we're going to remove this cardboard box and this foam for the poop shoot. Install the AMS unit by attaching two cables and your PTFE tubing. Next we're going to remove the silica package during plastic. So we're going to remove it from the plastic and then click them back in. Put in your spools and enjoy removing the plastic. Turn on the printer. Go through the calibration process and initial setup. Now you can finally remove the foam on the bottom once the bed moves up. Print your first benchy already sliced for you and saved in the machine. Be marveled at the print speed. This is in real time not set up. Pop off your print and enjoy the quality of your 24-minute benchy. Check out the extended version on my channel.