 Carefully strip approximately 50mm of the outer sheath ensuring you do not damage any conductor insulation. Carefully remove the inner cross filler. Place the wire manager over the conductors and push down to the start of the outer sheath. Arrange the conductors in the correct colour code. Typically this will be T568B. Place the conductors in the correct slots using just your fingers. A small pair of pliers can save strain over a large number of terminations. Using a pair of flush or side cutters cut the conductors flush with the side of the wire manager. Place the wire manager onto the IDCs and squeeze together the butterfly wings. To ensure the correct alignment follow the arrows on the outlet and the wire manager. Using a pair of pipe pliers gently squeeze together the butterfly wings until you hear a click to complete the termination.