 Welcome to the Snap. This is the segment where we answer frequently asked questions in a very rapid fire format, so let's get right into it. On this week's episode of the Snap, we are going to be discussing how to correctly assemble or disassemble a device using a BB9 or BB3 glass midsection. It's very important to take extra care when assembling a device with glass as it will be more fragile. What you need to assemble your device is your glass midsection, in this case a BB9, your tip, your cap, and some Dynawax. To start, let's begin by taking your tip and a small amount of Dynawax and we'll rub that into the O-rings on the tip. Rotate the tip a few times to ensure even coverage. This will help minimize the friction which in turn reduces the stress on the glass and O-rings. Take your lubricated tip and insert it into the tip end of your BB9 by pushing and twisting simultaneously. Do not attempt at assembling the device at an angle as it can overstress the glass and result in a fractured midsection. Finally, all you need to do is put your cap back on your device and you're good to go. If you want to know how to clean your glass, check out the video here. Don't you just hate it when that happens? Let us know your thoughts on the BB9 in the comments below and what would you like featured on the next episode. And that has been the Snap. Once again, I'm Retail Josh and thanks for watching.