Loading...

OpenTX 2.0 and Beyond - Episode 5 - Upgrading a Taranis to OpenTX 2.0

35,637 views

Loading...

Loading...

Transcript

The interactive transcript could not be loaded.

Loading...

Loading...

Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Nov 14, 2014

Updated WARNING: 1. Always use bootloader ("three finger salute") once you've updated to 2.0. 2. Put the Tx into bootloader mode BEFORE you connect the TX to the computer. 3. Use Safe disconnect method in Windows for both the Transmitter AND the SD card BEFORE disconnecting the TX from the computer.

NOTE:The first time you power the Taranis on after upgrading it will prompt you to format the EEPROM. Check through all model settings after upgrading

In this video I update a Taranis from stock firmware to OpenTX 2.0. I use a computer that has never had any of the FrSky or OpenTX software or drivers previously installed on it - this is it's maiden flight in the RC world.
The installation segment was filmed straight through in real time with no editing except to speed up a couple places so we would not watch a progress bar move slowly across the screen.

Installing OpenTX is not that difficult. Come join the party! Be sure to check out lessons on this and other OpenTX topics at Open-TX University - www.open-txu.org

Comments are disabled for this video.
Advertisement
When autoplay is enabled, a suggested video will automatically play next.

Up next


to add this to Watch Later

Add to

Loading playlists...