How to drag solder an STM32 to your CC3d





The interactive transcript could not be loaded.


Rating is available when the video has been rented.
This feature is not available right now. Please try again later.
Published on Jun 12, 2013

Just a quick clip to go over one of the more important steps of the build. I'd recommend having liquid no clean flux handy, your favorite solder, a 2-4mm tip (larger is actually better), and some solder braid to clean up any resulting bridges.
1) Align the part
2) flux and tack down 2 opposing corners
3) apply flux down one side and drag a drop of solder across the pins

Surface tension combined with enough flux, will wick the appropriate amount of solder from your iron and apply it to the legs.


When autoplay is enabled, a suggested video will automatically play next.

Up next

to add this to Watch Later

Add to

Loading playlists...